Magnetic Sludge Filter Installation in Lincoln

Whether you need an emergency plumber within the hour, or you're planning maintenance work, dealing with wear and tear, or upgrading old fixtures, we're here to help. We cover a wide range of properties, primarily focusing on homes (domestic), but also serving pubs, restaurants, factories and other commercial premises.

• Decades of Experience: Over 20 years in the plumbing and drainage industry.
• Fully Insured: We're insured for all types of jobs, so you can be confident in the quality of our work.
• Reliable & Cost-Effective: We prioritise customer satisfaction by providing a professional service at a fair price.
• Transparent Pricing: We offer clear pricing, including a per half-hour rate after the first hour.
• Trustworthy Service: We're committed to providing honest and exceptional customer care.

Sludge is a nasty mix of rust, limescale, and debris that builds up inside your central heating system over time. It forms because of corrosion within the pipes and radiators. If you let sludge get out of control, it can block pipes, reduce heat output from your radiators, and even damage your boiler.

Magnetic sludge filters are like super-powered magnets for your heating system. They're installed on your pipework and use a strong magnet to capture the iron oxide particles (the main component of sludge) as the water flows through. This keeps the sludge from circulating and causing problems.

Ideally, you should fit a magnetic filter when you're having a new boiler installed. This gives your new boiler the best chance of a long and healthy life. However, you can also install one on an existing system – it's never too late to start protecting your central heating!

Your plumber will usually install the magnetic filter on the return pipe, just before the boiler. This is the point where the water is flowing back to the boiler after circulating through the radiators, so it's the perfect place to catch any sludge that's been picked up.

While it might be tempting to save some money and do it yourself, we strongly recommend getting a qualified plumber to install your magnetic filter. Central heating systems can be complex, and if something goes wrong, you could end up with a leak or damage to your boiler. A professional will also make sure the filter is correctly sized for your system and installed in the optimal location.

Most manufacturers recommend cleaning your magnetic filter at least once a year. This involves isolating the filter, removing the magnet, and flushing out the collected sludge. Your plumber can do this as part of your annual boiler service.

While a magnetic filter is a great way to prevent sludge buildup, it won't necessarily solve existing problems caused by a system that's already heavily sludged up. In these cases, you might also need a power flush to remove the existing sludge before installing the filter.

Magnetic filters, in conjunction with system cleaning and inhibitor chemicals, can help with radiator cold spots. Cold spots are often caused by sludge settling at the bottom of the radiator, preventing it from heating up properly. By removing sludge from the system, the filter allows the hot water to circulate freely and heat the entire radiator.

Yes, if the system water is drained when you clean a magnetic filter, you will need to top up with inhibitor to protect against future corrosion. Always ask your installer to check the levels and top up.

Absolutely! A magnetic sludge filter is a relatively small investment that can save you a lot of money in the long run by protecting your boiler and improving the efficiency of your heating system. It helps keep your heating system working as it should for longer.